Home >> sunray satellite receiver >>10 X LOCTITE 454 Surface Insensitive Instant Adhesive Gel 20g
10 X LOCTITE 454 Surface Insensitive Instant Adhesive Gel 20g
10 units LOCTITE 454 Surface Insensitive Instant Adhesive Gel 20g
  • 10 units LOCTITE 454 Surface Insensitive Instant Adhesive Gel 20g
  • 10 units LOCTITE 454 Surface Insensitive Instant Adhesive Gel 20g
  • 10 units LOCTITE 454 Surface Insensitive Instant Adhesive Gel 20g

10 units LOCTITE 454 Surface Insensitive Instant Adhesive Gel 20g

Wholesale price: [ $130.00 ]
LOCTITE 454 Surface Insensitive Instant Adhesive Gel 20g

1. Universal instant adhesive gel
2. Will not drip or run.
3.Non-wicking, specially suited to porous materials
4. Perfect for all quick repairs;

if you want to know wholesale discount price,please contact us by e-mail.

Bookmark and Share

Note:
If your shipment is delivered to a remote area,this charge will be added to your shipping cost.Checking your area is a remote area or is not a remote area on the website:http://remoteareas.dhl.com/jsp/first.jsp

LOCTITE 454 Surface Insensitive Instant Adhesive Gel 20g Specifications:
Product Description:

LOCTITE 454 Surface Insensitive Instant Adhesive Gel 20g

LOCTITE?454??Prism Instant Adhesive Gel?
20g tube

Description:

LOCTITE ?454 is designed for the assembly of difficult-to-bond materials which require uniform stress distribution and strong tension and/or shear strength. The product provides rapid bonding of a wide range of materials, including metals, ?plastics and elastomers.

LOCTITE? 454 is particularly suited for bonding porous or absorbent materials such as wood, paper, leather and fabric. The gel consistency prevents adhesive flow even on vertical surfaces.

TYPICAL CURING PERFORMANCE:

Under normal conditions, the atmospheric moisture initiates the curing process. Although full functional strength is developed in a relatively short time, curing continues for at least 24 hours before full chemical/solvent resistance is developed.

Directions for use

1. Bond areas should be clean and free from grease. Clean all surfaces with a Loctite cleaning solvent and allow to dry.

2. Loctite Primer may be applied to the bond area. Avoid applying excess Primer. Allow the Primer to dry.

3. LOCTITE Activator may be used if necessary. Apply the LOCTITE? Activator to one bond surface (do not apply activator to the primed surface where Primer is also used). Allow the Activator to dry.

4. Apply adhesive to one of the bond surfaces (do not apply the adhesive to the activated surface). Do not use items like tissue or a brush to spread the adhesive. Assemble the parts within a few seconds. The parts should be accurately located, as the short fixture time leaves little opportunity for adjustment.

5. LOCTITE Activator can be used to cure fillets of product outside the bond area. Spray or drop the activator on the excess product.

6. Bonds should be held fixed or clamped until adhesive has fixtured.

7. Product should be allowed to develop full strength before subjecting to any service loads (typically 24 to 72 hours after assembly, depending on bond gap, materials and ambient conditions).